Resin Composites with S-PRG fillers may increase surrounding PH: Study
Researchers have found in a new study that resin composites with S-PRG fillers caused a slight, time-dependent increase in the surrounding pH. After erosive and abrasive challenges, surface roughness increased, but the gloss of S-PRG–containing composites showed improvement despite the rougher surface.
Composite resins containing S-PRG fillers may degrade under pH fluctuations and abrasion, influenced by their composition, particle size, exposure time, and solution acidity. Objective: This study evaluated the ability of resin composites containing S-PRG fillers to modulate the pH of the surrounding medium, as well as their surface roughness and gloss following an erosive/abrasive challenge. Methodology: Resin disks (⌀4mm × 2mm) (n=15) were prepared using Filtek Z350 XT (control), Beautifil II, Beautifil II Enamel, and Beautifil II LS (the latter three containing S-PRG fillers). To assess buffering capacity, disks (n=5) were immersed in a demineralizing solution, and pH was measured at baseline and after 1, 3, 7, 14, and 21 days. Separate specimens (n=10) underwent daily erosion cycles using 0.3% citric acid, combined with abrasion via toothbrushing, conducted over a 5-day period to simulate an acidic diet and twice-daily oral hygiene. Surface roughness (Ra) and gloss (GU) were assessed at baseline, after polishing, and following the challenge; surface topography was analyzed by a scanning electron microscope (SEM). Data were analyzed using a generalized linear mixed model for repeated measures over time, in addition to Tukey–Kramer, Kruskal–Wallis, Dunn, Friedman, and Nemenyi tests (α=0.05). Results: All materials showed a significant increase in the pH of the surrounding medium over time (p<0.05). After 24 hours, Beautifil II exhibited a significantly higher pH than the others (p<0.05). Filtek Z350 XT demonstrated lower surface roughness than the other materials after the erosive/abrasive challenge (p<0.0001). Following the challenge, Beautifil II and Beautifil II Enamel presented higher gloss values (p<0.05). Conclusions: Resin composites containing S-PRG fillers slightly increased the pH of the surrounding medium over time. Surface roughness increased after the erosive/abrasive challenge, although the gloss of the S-PRG-containing composites also improved.
Disclaimer: This website is primarily for healthcare professionals. The content here does not replace medical advice and should not be used as medical, diagnostic, endorsement, treatment, or prescription advice. Medical science evolves rapidly, and we strive to keep our information current. If you find any discrepancies, please contact us at corrections@medicaldialogues.in. Read our Correction Policy here. Nothing here should be used as a substitute for medical advice, diagnosis, or treatment. We do not endorse any healthcare advice that contradicts a physician's guidance. Use of this site is subject to our Terms of Use, Privacy Policy, and Advertisement Policy. For more details, read our Full Disclaimer here.
NOTE: Join us in combating medical misinformation. If you encounter a questionable health, medical, or medical education claim, email us at factcheck@medicaldialogues.in for evaluation.